Have you ever asked yourself this question: where can I buy funko pop protectors? Or maybe you had even cause to ponder: how do I create funko pop protectors? Perhaps you’ve considered this profound question a few times. It’s not as hard as you think it might be. All you need is a few minutes and a few supplies; then, you can enjoy your favorite gaming figurines in their own little box. You can follow the steps given below if you want to make Funko Protectors.
Step 1: Materials.
You will need:
- A funko pop box
- Scissors
- Duct tape or packing tape
- A knife (optional)
Step 2: Cutting the Box.
Fold the box in half and cut off the front flaps to make the lid. Cut the side flaps off, and then cut around one inch from each side of the bottom piece so that it fits snugly inside of your top piece.
Step 3: Glue the plastic pieces together to enclose the box.
Make sure that it fits snugly around your Pop, with about half an inch of space between the figure and the plastic all around.
Step 4: Cut out two small holes in one of the long sides of the box.
These holes are where you’ll put your fingers to grip the box when you move it.
Step 5: Let the glue dry.
The best choice is to use a glue gun because it dries rather quickly. The most important thing to remember is that you want the glue to dry completely before you put the lid on your funko pop storage box.
Looking For A Funko Pop Protector Manufacturer?
If you are looking for funko pop hard case bulk or funko pop hard case wholesale, then get in touch with Pop Protectorsy!
